Silca Unocode 299 - REFERENCE GUIDE

Operating manual - English UNOCODE 299
Copyright Silca 2002 1
REFERENCE GUIDE
This manual has been produced to serve as a guide for users of the UNOCODE 299 electronic key-cutting
machine. Read it carefully; it is essential if you wish to operate your machine safely and efficiently.
C ONSULTATION
The contents of the manual are divided into sections relating to:
• Machine description ..................................................................................... Chapter 1
• Transport and installation ............................................................................ Chapters 2-3
• Regulation and use ...................................................................................... Chapters 4-5-6
• Maintenance ................................................................................................ Chapters 7-8-9
T ECHNICAL TERMS
Common technical terms are used in this manual.
To assist those with little experience of keys and key-cutting, below is an illustration of the terms most
frequently used.
Fig. 1
1) Head
2) Rim
3) Stop
4) Stem
5) Tip
6) Back
7) Cuts
2
1
5
3
6
4
1
3
7
5
7
2