Silca Unocode 299 - 7.6 ELECTRONIC CIRCUIT BOARD REPLACEMENT

Operating manual - English UNOCODE 299
Copyright Silca 2002 53
7.11 BRUSH REPLACEMENT
1) open the rear compartment (ch. 7.8, page 50).
2) unscrew the two brush caps (M4) (fig. 51), remove and fit two new brushes.
3) replace the two caps (M4).
4) close the rear compartment.
5) carry out Test 7 to check proper operation (ch. 5.6.1, page 31).
Fig. 51
M4