UNOCODE 299 Operating manual - English
38 Copyright Silca 2002
7-P
REFERENCES
:
work parameters are chosen from this menu
.
Inches or millimetres
:
choose the measurements you intend to work
with (mm = millimetres, inch. = inches).
Start-up menu
:
choose the function in the Main menu that you
would like to appear first when the machine is
turned on:
* = Main menu
1 = Copy by code
2 = List of codes
3 = Queue from PC
4 = Calibrations
Attention: press the “CLEAR/COPY” key to void
any selection made and to select the (*) main
menu function.
Quick menu
:
when enabled (=1) some operational functions
will be skipped (if admissible).
e.g. when ‘0’ is set, the display shows the following
when the machine is turned on:
8-
L
ANGUAGE
:
enter the number that corresponds to the
language you intend to work with
.
9-O
PTICAL READER
:
function not available.
10 - K
EYBOARD INVERSION
This function inverts the alphanumerical
keyboard (numbers to letters (fig. 9, page 12).
With “Inversion keyboard” disactivated (0) :
• to digit number 1: press
• to digit the letter H: press SHIFT +
With “Inversion keyboard” enabled (1) :
• to digit number 1: press SHIFT +
• to digit the letter H: press
NOTE: this function can be carried out from the main menu“ Copy by code” and/or “List of codes” .
mm [0] inch. [1] = 0
Start Menu = * (0-3)
Quick Menu = 0 (0-1)
ORIGINAL on right.
Clamp = 100/_? (ABCD)
Pos. = 0 (0-4)
Dist.= 000 [START]
Select language = 2
1 : Italiano 2 : English
3 : Deutsch 4 : Français
5 : Español
Inversion keyboard
function = 0
(1 - enabled)
see Operating manual
H
1
H
1
H
1
H
1
To Next Page
Loading...
