Silencer 75SL - Tamper Disarming; Pathway Illumination; Two-Steps Door Unlock; Automatic Re-Arm

UM_FULL_75SL_REV_A 10
TAMPER DISARMING: If the alarm has been triggered, upon disarm the system’s siren will chirp 4 times and the
parking lights will ash 3 times telling you the alarm has been triggered during the last armed state and the triggered
Icon will display on the LCD screen.
PATHWAY ILLUMINATION: When receiving an unlock /disarm signal, this feature will turn the parking lights
“ON” for 30 seconds and for 10 seconds upon the lock signal.
TWO-STEPS DOOR UNLOCK (Optional): This feature will independently unlock the driver’s door only
when disarming the security system.
• Pushing the button a second time within 3 seconds will disarm the security system and unlock the other doors.
• Press and hold the button for 1.0 seconds, within 3 seconds presses the button will Silent Disarm the
security system and unlock the other doors.
AUTOMATIC RE-ARM: If this feature is selected, the security system will automatically re-arm itself in
60 seconds after disarming with remote transmitter. Automatic rearm will cancel if any door is opened
before the 60 seconds timer has elapsed.
I. TRIGGER THE SYSTEM:
When armed, your vehicle is protected as follows:
Light impact will trigger the warn-away signal. Heavy impacts / Doors open / Trunk open / Hood
open / Turn on the ignition key / lift the vehicle will trigger the programmed sequence and the trigger
icon will ash the icon and trigger zone fault report will display on the LCD screen. The starter disable relay
(if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking lights, and dome light will turn on for
30 seconds, alerting of an intrusion. It will then stop, automatic reset and re-arm. If any one of the sensors or detectors
is still active, the alarm system will sound a maximum of 3 times. Each time is a 30 second cycle.
NOISE ABATEMENT CIRCUIT: Your system has a “Noise Abatement Circuit”. It prevents annoying repetitive trigger
sequences due to faulty door pin switches or environmental conditions such as thunder, jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers ve times. Each time, It’s all shock sensor triggers
the alarm; the “Noise Abatement Circuit” will interpret this pattern of triggers as a false alarm. After the fth trigger,
the “Noise Abatement Circuit” ignores, or bypasses the shock sensor until a different sensor or switch is triggered.
“Noise Abatement Circuit” covers doors (Trunk / Hood / Tilt Sensor / Ignition Switch) differently: If the alarm is
triggered by an open door for three full cycles, the doors will be bypassed until the trigger ceases.
J. PANIC FUNCTION:
Press and hold the button for 3 seconds until the beep conrms and then release the button to activate the
personal protection alarm and the icon will display on the LCD screen. During panic mode, the normal function of
the transmitter buttons will be suspended. The transmitter and buttons can be used to lock and unlock the door
(if the option is installed). To stop the alarm, press and hold the button on the transmitter again for 3 seconds. The
system will automatically stop after 30 seconds.