Silencer 75SL - Remote Start Operation; To Remote Start the Vehicle; Programmable Safety Start

UM_FULL_75SL_REV_A 14
WARNINGS
As with any product that performs automatic functions, there are certain safety precautions
that you must practice and be aware of.
1. Keep the transmitter out of children’s reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it’s in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. The vehicle windows must be rolled up.
7. Should the unit malfunction, disconnect the fuse until the problem is corrected.
8. The use and operation of this system is the sole responsibility of the operator.
9. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.
10. It is not safe to remote start the vehicle if the vehicle is parked on a steep incline.
REMOTE START OPERATION
A. To Remote Start The Vehicle
When you want to start your vehicle:
1. Press the button once on the transmitter.
2. The parking light will activate to indicate the remote start has received the signal
and the icon will scroll to indicate that the engine is starting.
3. After a couple of seconds with the engine running, the icon will show on the LCD screen,
the parking lights will turn on and the climate controls will activate to adjust the vehicle’s interior
temperature to your preset setting. While the vehicle is running, the icon, the run time start countdown
text and tones play to conrm. The countdown timer based on the 3, 10, 20, 30 or 45 minute run time
set up by your installation center.)
4. The vehicle will run for a programmable 3 to 45 minute cycle before shutting down. When the countdown
timer is off or press button, the system will be shut down, and the icon will disappear and tones
play on the LCD screen.
5. The vehicle refused to start running after 3 unsuccessful attempts.
6. If Remote Start fails to start, the parking light will fast ashing 4 times and text
and a fault tone play on the LCD transceiver.
B. Programmable Safety Start
By default, your Silencer remote starter is programmed to start/stop after pressing the button
1 time. This default
setting can be re-programmed to require 2 presses - . This setting is known as “Child Safety Mode”.
Contact your installer to reprogram this feature if needed.