Silencer 75SL - Aux 4 Timer Control Output; Second Car Opreation; Power on Memory; Stop the Trigger Melody Sound

UM_FULL_75SL_REV_A 13
T. AUX 4 (CH 4) TIMER CONTROL OUTPUT. (Optional Feature)
Press F button 3 times rst then press button or press the buttons + simultaneously to activate
Aux 4 function and. the text and tones play to conrm. Aux 4 is a user-programmable timer output.
Programmable Output: Aux 4 Latch / Aux 4 Latch Reset with Ignition / Aux 4 Flex /
(Aux 4 Control by Remote / Control by Arm / Control by Disarm / Control by Arm & Disarm / Control by Remote Start)
U. SECOND VEHICLE SECURITY OPERATION.
You can be utilized to control a second vehicle’s security system. To program the remote control transmitter
to a second vehicle, Press and hold the + buttons 2 seconds until the beep conrms and then release
the button to select car 2 or car 1 operation.
4 Button Remote Transmitter:
For Car 2: When the LED start 2 pause ash then release buttons.
For Car 1: When the LED start 1 pause ash then release the buttons.
LCD Remote Transceiver:
For Car 2: When 2 icon and the text show on the LCD display then release the buttons.
Under Car 2 mode, the 2 icon will ash.
For Car 1: When 2 icon is disappear and the text show on the LCD display then release the buttons
V. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state
if the power is lost and then reconnected.
W. CLEAR THE FLASHING TAMPER WARNING MESSAGE ICONS:
The ashing warning message icons in the LCD display will clear and reset when the transmitter
is used to lock the vehicle. Also, Locking then Unlocking the system will clear the ashing icons.
X. STOP THE TRIGGER MELODY SOUND:
While triggering the alarm, the LCD screen will alert the user through a melody sound and a ashing trigger icon.
Press any button on the LCD remote transmitter to stop the melody sound only.
Y. ILLUMINATE LCD DISPLAY:
Press and hold the F button for 1 second and the LCD indicator will light up.
Z. OUT OF REMOTE CONTROL RANGE:
If the icon disappears to indicate the remote failed to receive a command conrmation.