22
422348-Evolution ST350-Instruction manual-usa-rev01_AN
Before treatment make sure that:
• All jewelry must be removed.
• Place the contact electrode covered with wet gauze, under the shoulder, when working around face area or
upper body or under the thighs when working on lower body.
(-) ANAPHORESIS
“Anaphoresis” will be applied BEFORE depilation treatment to open hair follicles. NEVER use “Ana” after depilation
treatment.
• Apply some water with a cotton wool pad.
• Use the roller electrode over the treated area for 3 minutes. (Never use metallic roller on bare skin).
• Rinse the skin.
• To prevent electrode deterioration, use bactericidal wipes to disinfect roller.
CAUTION:
• NEVER use the roller directly on the skin (without gel).
• For roller maintenance clean all gel residues on the roller after each use.
• Use bactericidal wipes to disinfect the roller.
Treatment should be comfortable and soothing pre electrolysis.
Client should only feel slight tingling.
Lower intensity if client is uncomfortable.
A tingling may also be felt under the contact electrode (make sure the electrode is covered with wet gauze).
Recommended intensity settings for “Ana“(Before electrolysis):
• For Face: 0.30 mA to 0,80 mA
• For Body: 1.00 mA to 1,50mA
(+) CATAPHORESIS
Cataphoresis will be applied AFTER each depilation treatment to sooth the skin and to help skin penetration of the
actives positively charged.
Treatment procedure for Cataphorese:
• Apply a layer of Sensiblis Gel (post-depilation soothing gel).
• Use the roller electrode over the treated area for at least 3 minutes. (Never use metallic roller on bare skin).
• Remove gel and rinse the skin.
• To prevent electrode deterioration, remove gel residue from roller electrode.
• Use bactericidal wipes to disinfect roller.
To Next Page
Loading...