24
422348-Evolution ST350-Instruction manual-usa-rev01_AN
Timer
1 option is available:
True Time Mode: Can be used to countdown a pre-set time. Useful to control time with a client.
The choice of Timer mode is selected by using the “Treatment Duration” bar.
• True Time Mode: To use the timer as a countdown timer, select the desired treatment time, using the “up” or
“down” arrow keys on the timer panel. It will change by 5 minutes increments. Next, press the “True Time” key
to turn the timer on. The blue indicator will confirm the timer is counting down. You can press the “True Time”
key to pause or activate the timer.
• At the end of preselected period of time a “Beep” sound will be emitted.
Insertion Delay (automatic current activation mode)
The Sensor Delay key is used to work in the automatic current activation mode, without the pedal. The “Sensor
Delay” is the interval of time between the beginning of your insertion into the follicle and the activation of current
passage. This delay time can be modified to suit the technician’s dexterity and difficulty encountered at the treated
area. The delay may be set from 0.5 sec to 5 sec., in 0.1s increments. This mode will contribute to the technician’s
comfort and reduce lengthy work fatigue. Using the “Sensor Delay” necessitates a certain amount of dexterity. The
probe must always be accurately inserted into the follicle at the moment of current activation.
IMPORTANT NOTE:
• It is not recommended to work with the “Sensor delay” mode when work areas present difficult insertions
or tight follicles.
• If you are not familiar or comfortable with the Insertion delay technique, set the delay time to 2.5 seconds or longer.
Insertion counter
Registers the number of times the current is actually activated during a specific treatment. Pressing the “Insertion”
key for more than a second will reset the insertion counter.
To Next Page
Loading...