12
422348-Evolution ST350-Instruction manual-usa-rev01_AN
05. Unit settings
IMPORTANT: EVOLUTION ST350 system uses a touchscreen interface. It is highly recommended that
you carefully read and understand the instructions manual to properly use your electrolysis system by touching
“Instructions” button in the bottom of the screen.
CAUTIONS: The touch screen interface is very sensitive, therefore:
• ALWAYS use the screen pen provided with the unit to touch the screen. There is no need to press hard for a
response.
• NEVER use sharp objects as these may damage the screen.
• NEVER put the probe holder or the tip of the needle in contact with the screen surface. The probe carries high
voltage and will damage the screen.
Turning the unit ON:
CAUTIONS: Never proceed to use the unit if the display screen is inoperative.
1. To turn the unit on, use the power switch located at the back of the unit. Switch to the «ON» position.
Then Silhouet-tone logo will appear.
2. The computer will take approximately 15-30 seconds to load all programs.
3. The unit is ready to use when the screen displays “Depilation”and “Soothing phase”
4. Function selection: touch desired key to access the main “Treatment Menu”.
Treatment selection
WARNING: Never touch the screen with the probe.
• Use this screen to select treatments
To Next Page
Loading...