Pull the thread through the slit (A).
Inserting the bobbin
10
Attention: Turn power switch to off ("O")
before inserting or removing the bobbin.
When inserting or removing the bobbin, the
needle must be fully raised.
Insert the bobbin in the bobbin case with the
thread running in a counterclockwise direction
(arrow).
With a finger held gently on top of the bobbin.
the thread at the arrow markings into the
stitch plate thread guide from (A) to (B)
Draw
.
Pull the thread at the arrow markings into the
stitch plate thread guide from (B) to (C).
To cut off excess thread pull thread back over the
cutting off blade at point (C). Close the bobbin
cover plate.
A
C
A
B
B
To Next Page
Loading...
