Select pattern 20 to get the darning stitch.
Chang the presser foot to the buttonhole foot.
Pull the button holder to rear.
Set the button guide plate on buttonhole foot to
the desired length.
Baste the upper fabric and the under fabric
together. Select the needle position. Lower the
presser foot over the center of the tear.
The size of one darn cycle is variable.
However, the maximum stitch length is 2.6cm (1
inch) and the maximum stitch width is 7mm
(9/32 inch).
a. The length of sewing.
b. The width of sewing.
31
Darning stitch
Position the fabric so that the needle is 2mm
(1/16 inch) in front of the area to be darned, and
then lower the presser foot lever.
When lowering the presser
foot, do not push in the front of the presser
foot, otherwise the darning will not be sewn
with the correct size.
Please Note:
3.5~7.0
1.0~2.0
20
2mm
D
To Next Page
Loading...
