Attention: During the sewing, if the thread get jammed inside the hook stopping the needle from moving
and you continue pressing the foot control, the security switch will stop the machine completely. In order
to restart the sewing machine, you will have to turn the on/off switch to the OFF position and then ON
again.
Warning functions
- When operating correctly: 1 beep
- When operating incorrectly: 3-short beeps
- When the sewing machine is in trouble and can't sew: 3-short beeps
It means that the thread is twisted or jammed and the hand wheel axle can't move. Please look t hrough
the "Trouble shooting guide" on page 48/49 to find the solution. After the problem has been solved, the
machine will continue to sew.
Warning beeping sound
Please Note: If the problem is still not solved, please contact your local dealer.
46
Return bobbin winder spindle to left
If you press any button on the machine when the
bobbin is full or the bobbin winder spindle is in
the right position, then the machine will beep 3
times as a warning.
Return the bobbin winder spindle to the left
position.
Maintenance
Cleaning the sewing machine surface
If the surface of the sewing machine is dirty, lightly soak a cloth in mild detergent, squeeze it out firmly
and then wipe the surface. After cleaning it once in this way, wipe the surface again with a dry cloth.
Attention: This machine is equipped with a 100mW LED lamp. If lamp replacement is needed, please
contact nearest authorized retailer.
Cleaning the hook
If lint and bits of thread accumulate in the hook, this will interfere with the smooth operation of the
machine. Check regularly and clean the stitching mechanism when necessary.
Attention: Disconnect the machine from the wall outlet before carrying out any maintenance.
To Next Page
Loading...
