Silver 1035 - Changing the Presser Foot; Attaching and Removing Presser Feet; Attaching the Edge;Quilting Guide

d
c
f
b
e
a
e
b
a
Changing the presser foot
Attention: Turn power switch to off ("O") when carrying out any
of the below operations!
Attaching the presser foot holder
Attaching the presser foot
Removing the presser foot
Attaching the guide
Raise the presser foot bar (a).
Attach the presser foot holder (b) as illustrated.
Lower the presser foot holder (b) until the cut-out (c) is directly above
the pin (d).
Press the black lever (e).
Lower the presser foot holder (b) and the presser foot (f) will engage
automatically.
Raise the presser foot.
Press the black lever (e) and the foot will disengages.
Attach the guide (g) in the slot as illustrated. Adjust
according to need for hems, pleats, etc.
edge/quilting
edge/quilting
g
5