Silvercrest SEAD 1800 B1 - Preparing for First Use; Initial Setup and Water Filling

7
GB
~ Only transport the device when it has
cooled down.
~ Wait for the device to cool down before
cleaning.
DANGER! Risk of injury
through scalding
~ Do not lean over the Electric Preserver &
Jam Maker when you open the lid and
the contents are still hot.
There is a dan-
ger of being scalded by escaping steam.
WARNING! Risk of material
damage
~ Never operate the appliance without
water or liquid. This could result in the
device overheating.
~ Make sure there is never too much liq-
uid in the appliance. The level of liquid
must always be below MAX. If there is
too much liquid, the appliance might
overflow.
~ Never place the device directly under a
wall-mounted cupboard, as steam
comes out from the top and could dam-
age the furniture.
~ The appliance and accessories may not
be put in a microwave oven.
~ Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
~ Only use the original accessories.
~ The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have ingredients that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
~ Do not use any astringent or abrasive
cleaning agents.
4. Items supplied
1 Electric Preserver & Jam Maker, compris-
ing:
- 1 container3
-1 lid1
-1 rack13
1 operating instructions
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
5. Before using for the
first time
FIRE HAZARD! Before turning the
device on, place it on a level, sta-
ble, dry, heat-resistant surface.
DANGER! Risk of injury
through burning!
The surfaces of the device become
very hot during operation.
Only use
the handles and control elements
provided
.
NOTE: as the appliance is supplied with a
thin film of grease, there might be a small
amount of smoke and odour the first time
it is used. This is not harmful and will stop af-
ter a short while. Please ensure adequate
ventilation during this process.
• Clean the appliance before using
it for the first time (see “Cleaning
and storing” on page 13)!
1. Unwind the mains cable12 from the
cable store8 over its entire length.
2. Place the appliance on a level, dry,
non-slip surface so that the appliance
can neither fall over nor slide off.
3. Insert the power supply plug12 in a
suitable earthed mains socket.
4. Add around 5 l water to the container 3 .
BB&3(B%ERRN6HLWH)UHLWDJ1RYHPEHU