SKGE 2000 C3
GB│IE
│
15 ■
Cleaning and care
Safety instructions
WARNING! DANGER TO LIFE DUE TO ELECTRIC SHOCK!
Risk of injury when cleaning the appliance!
To avoid risks, observe the following safety instructions:
► Before cleaning, pull out the plug and wait until the appliance has
completely cooled down. Risk of injury!
► Never clean the appliance under running water and never immerse it in water.
The appliance could be irreparably damaged!
CAUTION
Damage to the appliance!
► To avoid irreparable damage to the appliance, ensure that no moisture can
penetrate the appliance during cleaning.
► When cleaning the surfaces use neither abrasive or chemical cleaners, nor
sharp or scratchy objects.
■ Draw the cleaning scraper w over the hotplates 0 after the hotplates 0
have cooled down so that fat and residues are aggregated, and then slide
them into the fat collector tray 7.
■ Wipe the hotplates 0 with a damp cloth. Do not use any abrasive cleaning
agents, rough sponges or sharp objects for cleaning as these could damage
the non-stick coating.
For more stubborn soiling or hardened residue, remove the hotplates 0:
– Open the appliance.
– Press the RELEASE button 8 and at the same time, remove the lower
hotplate 0.
– Hold the upper hotplate 0 in place to prevent it from falling and press
the RELEASE button q. The upper hotplate 0 is released from the
appliance.
Clean the hotplates 0 which have been removed in warm water with a little
detergent in it. For severe incrustations, leave the hotplates 0 to soak for a while
in the water. After washing, rinse the hotplates 0 with clean water to remove all
detergent residues. Dry everything properly. The hotplates 0 must be dry before
you put them back in the appliance!
To Next Page
Loading...
