51
GB
2. Press the unlocking lever34
on the underside of the blender
jug5 so that it points to the
open lock symbol.
3. Pull out the blade assembly27 carefully
towards the top.
In order to insert the blade assembly27,
proceed as follows:
4. Position the blender jug5 horizontally.
5. Insert the blade assembly27 from the
top.
Please take note that the two cams at
the bottom of the blade assembly27
must be pushed through the two recess-
es in the underside of the blender jug5.
CAUTION: ensure that the seal26 for the
blade assembly27 is positioned correctly,
since otherwise the content may escape.
6. In order to lock the blade as-
sembly27, move the unlock-
ing lever34 on the underside
of the blender jug5 so that it
points to the closed lock symbol.
NOTE: chop large pieces into smaller ones
with an edge length of approx. 3 - 4 cm.
Otherwise larger pieces might get stuck in
the blades.
10.3 Insert blender jug
1. Place the blender jug5 into the holder
for the blender jug9.
2. Press the blender jug5 slightly down-
ward until the cog wheel of the blade
assembly27 locks in place in the gear
ring of the holder9.
NOTES:
• If the blender jug5 cannot be pressed
downward, “wobble” slightly so that the
cog wheel of the blade assembly27 in
the blender jug5 will slide into the gear
ring of the holder9.
• Should the blender jug5 not be posi-
tioned correctly, a safety mechanism
prevents the functioning of the device.
The display25 shows E2.
10.4 Insert and remove the
mixer attachment
The mixer attachment29 serves to combine
liquid foods, e.g. to whip cream, beat egg
white, emulsify (e.g. mayonnaise).
The mixer attachment29 is put onto the
blade assembly27:
- The wings of the mixer attachment
29
are
located in the spaces between the blades.
- For further notes: see “Functions in an
overview” on page 38.
CAUTION:
~ The mixer attachment29 must only be
used with speed settings 1 to 4.
~
The pulse button
18
must not be pressed
if the mixer attachment
29
is used.
~ When using the mixer attachment29,
the spatula30 must not be used, since it
might get into the mixer attachment29.
~ When adding food, ensure that it will
not block the mixer attachment29.
In order to remove the mixer attachment29,
pull it out upward.
BB&3(B(6ERRN6HLWH)UHLWDJ-XQL