Silvercrest SKMK 1200 A1 - Error Messages on the Display

62
GB
16.2 Error messages on the display
Display Cause Remedy
E3
The device is overloaded.
Odour / smoke may devel-
op.
• The appliance can be used to pro-
cess up to max. 500g of flour.
• Let the device cool down completely.
Afterwards, it is ready for use again.
Lid32 or deep steamer bas-
ket3 have not been placed
correctly onto the blender
jug5.
Close lid32 correctly (see “Put on the lid
of the blender jug” on page 52).
Or close steamer basket3 correctly (see
“Preparation of the steamer inserts” on
page 54).
HHH
Temperature in the blender
jug5 is too high. There is
not enough food or liquid in
the blender jug5
Switch the device off and let the blender
jug cool down. Then add a sufficient
amount of food or liquid into the blender
jug5.
E2
The blender jug5 is not in-
serted correctly.
Insert blender jug5 correctly (see “Insert
blender jug” on page 51).
- - - - The scale is overloaded. Remove some weight from the scale.
BB&3(B(6ERRN6HLWH)UHLWDJ-XQL