Silvercrest SKMK 1200 A1 - 16. Malfunctions, Cause, Remedy; Malfunctions during Operation

61
GB
16. Malfunctions, Cause, Remedy
16.1 Malfunctions during operation
Malfunction Cause Remedy
Device does not start.
Blender jug5 is not posi-
tioned correctly
Insert blender jug5 correctly (see
“Insert blender jug” on page 51).
Lid32 or deep steamer bas-
ket3 have not been placed
correctly onto the blender
jug5.
Place lid32 or deep steamer bas-
ket3 correctly.
No power supply
Check mains plug7, main
switch6 and possibly the fuse.
Liquid underneath the
device
The blade assembly27 has
not been inserted correctly so
that the blender jug5 is leak-
ing.
Insert blade assembly27 correctly
(see “Using and removing the
blade assembly” on page 50).
Seal26 for the blade assem-
bly is defective.
Insert new seal26 (see “Clean-
ing, checking and replacing seals”
on page 59).
Liquid escaped from the
blender jug5 flowing onto
the surface through the over-
flow hole10 of the base
unit12. (see “Overflow” on
page 49)
When mixing liquids at speed 10
or with button TURBO18, the
blender jug5 must not contain
more than 1 litre, since otherwise
liquid may be ejected. For speed
settings of less than 10, the blend-
er jug5
may only be filled up to a
maximum of 2.2 litres.
Liquid escapes at the
lid32 of the blender
jug5
Seal31 has not been inserted
correctly.
Insert seal31 correctly (see
“Cleaning, checking and replac-
ing seals” on page 59).
Seal31 is defective.
Insert new seal31 (see “Clean-
ing, checking and replacing seals”
on page 59).
No temperature can be
set.
A speed setting 4 - 10 was se-
lected.
Select speed setting 0 - 3 (see “Set-
ting the speed” on page 48)
Parts of the device are
discoloured.
Certain food or spices (e.g.
curry) may discolour plastic.
This is not a defect with the de-
vice
Remedy unnecessary, since not
harmful to health.
A speed setting ex-
ceeding 3 cannot be
selected.
A temperature has been set. Set temperature to 0.
BB&3(B(6ERRN6HLWH)UHLWDJ-XQL