GB
│
IE
│
NI
│
15 ■
SKR 800 C3
NOTE
► Press the
|
MEM button z or the
|
AMS button e to show the
alarm time for a few seconds in the display 4.
► In the event of a power failure, any programmed alarm times will be deac-
tivated and not reactivated when the power comes back if no batteries are
inserted in the battery compartment
d.
Interrupt alarm (SNOOZE function)
♦ You can interrupt the alarm for 9 minutes by using the SNOOZE function. To
do this, press the SNOOZE
|
SLEEP button t as soon as the alarm sounds.
If the SNOOZE function is active, either or or or flashes in
the display 4 depending on the alarm type which has been set.
Switching off the alarm
♦ While the alarm is sounding, press either the
|
MEM button z or the
|
AMS button e or the −VOLUME+ | /FUNC. dial 1 to switch off
the alarm for 24 hours.
NOTE
► If the alarm is not manually deactivated, the device will switch off the alarm
automatically after 1 hour.
Switching the alarm off completely
Requirement: The device is in clock/standby mode.
♦ To switch off Alarm 1 or Alarm 2 completely, press the
|
MEM button
z or the
|
AMS button e for about 2 seconds until the alarm time
hours flash in the display 4.
♦ Press the
|
MEM button z or the
|
AMS button e until the alarm
type or or or flash in the display 4.
♦ Turn the −TIMER+ dial
8 to the right to set the alarm type to (Off).
♦ Press the
|
MEM button z or the
|
AMS button e to save the
setting.
Switching the radio mode on/off
NOTE
► The technical features of this device enable an adjustable reception capa-
bility that exceeds the permitted FM frequency range of 87.5–108MHz.
In some countries, different national regulations may apply to the assigned
radio frequency ranges. Please note that information received outside of the
assigned radio frequency ranges may not be exploited, passed on to third
parties or otherwise misused.
♦ Briefly press the −VOLUME+ |
/FUNC.dial 1 to switch the device on.
To Next Page
Loading...
Need help?
General
