EasyManuals Logo

Silvercrest SKR 800 C3 User Manual

Silvercrest SKR 800 C3
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
GB
IE
NI
 17
SKR 800 C3
Receiving stations in mono
If you would like to receive a station in mono, press and hold the
|
ST/
MO button
q for around 2 seconds until 4 ST for stereo reception goes
out in the display.
NOTE
ST is only displayed if the station can actually be received in stereo.
If you would like to switch back to stereo reception, press and hold the
|
ST/MO button q again for around 2 seconds until ST for stereo
reception is shown in the display
4.
Kitchen timer
The device has a practical kitchen timer with which you can monitor cooking and
baking times, for example. You can set 2 kitchen timers.
Setting and operating the kitchen timer
Turn the −TIMER+ 8 dial right or left to set Timer 1. flashes in the
display 4.
NOTE
Timer 1 can be set in steps of 1 minute from 1 minute up to 3 hours
59 minutes. If you set the countdown to between 1 minute and 4 minutes,
the time is shown as "mm:ss". If you set the countdown to 5 minutes or
more, the time will be shown as "hh:mm".
If no change is made to the setting for about 15 seconds, the device will
switch back to the previous operating mode without saving the settings.
Press the −TIMER+ dial
8 to accept the setting. The display lights up
and the countdown for Timer 1 starts immediately.
Press the button 3 to set Timer 2. flashes in the display 4.
NOTE
Timer 2 can be set in steps of 5 minutes from 5 minutes up to 3 hours
55 minutes. The time is given as "hh:mm".
If no change is made to the setting for about 15 seconds, the device will
switch back to the previous operating mode without saving the settings.
Press the −TIMER+ dial
8 to accept the setting. The display lights up
and the countdown for Timer 2 starts immediately.
The countdown for Timer 1 and Timer 2 gives a warning beep at 30, 15,
10 and 5 seconds before expiry to indicate the alarm time.
At the end of the countdown, an alarm signal with rising volume sounds.
Press the −TIMER+ dial 8 or the −VOLUME+ | /FUNC. dial 1 to
switch off the alarm. Timer 1 or Timer 2 goes out.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SKR 800 C3 and is the answer not in the manual?

Silvercrest SKR 800 C3 Specifications

General IconGeneral
BrandSilvercrest
ModelSKR 800 C3
CategoryRadio
LanguageEnglish

Related product manuals