Entering basic settings
48
System Configuration
Select the sub-menu “System Configuration“.
Confirm by pressing the “OK” key.
Here, the software and hardware version of the receiver is displayed.
Factory Settings
You can restore the original company settings (default settings) at
any time. After that, the installation assistant will be invoked
automatically, see initial installation.
You can also delete the channel
list completely.
The receiver is reset to its original settings. All your settings
and stored data are deleted.
Then, you must restart the
channel scan.
Select the sub-menu “Factory settings“.
Select “Restore Factory settings“ if you wish to reset the receiver
to its pre-programmed state.
Select “Delete all Programs“ if you
wish to delete the channels in the TV and radio channels list.
Press “OK“.
On the screen, a warning message appears.
Select “Yes“ to restore the company settings or to delete all
channels.
Select “EXIT“ if you want to exit the menu.
To Next Page
Loading...
Need help?
General
