Safety instructions
8
Safety instructions
Please read the safety instructions carefully before operating the
receiver.
Please follow all warnings and instructions on the equipment and in
the operating manual.
Basic safety instructions
Electrical connection
• Disconnect the receiver from the power source in case of
operational disruptions. Please note: The receiver will remain live,
even if it is turned off with the mains switch on the rear side.
• Do not expose the receiver to rain or any kind of humidity to avoid
risk of fire and electric shock.
• Never open the casing. Otherwise, there is a risk of electric
shock.
• Connect the receiver only to a professionally installed mains
socket of 100–240 V, 50–60 Hz.
• Pull out the mains plug from the socket if the equipment is not in
use for a longer period of time. Only pull at the mains plug, not at
the cable.
• Pull out the mains plug of the receiver and the antenna plug of the
roof antenna (if any) from the socket in case of storms.
• If foreign bodies or fluids enter the receiver, immediately pull out
the mains plug from the socket. Ask a qualified person to check
the equipment before operating it once again. Otherwise, there is
a risk of electric shock.
• Ensure that the power source (socket) is easily accessible.
• Do not bend or crimp the mains cable.
• If the mains cable is damaged, the receiver must be repaired by
an expert before reusing it. Otherwise, there is a risk of electric
shock.
• Never allow children to operate the receiver or to play with the
antenna unit unless supervised.
To Next Page
Loading...
Need help?
General
