23
The following will again appear on the display:
followed by the confirmation message
.
The remote control will then revert back to normal use.
Entering a device code from the code list
The codes for the corresponding devices are stated on
the code list included with this instruction manual.
Turn the device on.
Hold down the setup (17) button for about 3
seconds until
is shown.
Press OK (12) . will then appear on the
display.
Select the menu using the navigation
buttons (13) .
Press OK (12) . The display will show .
Press the appropriate source button (2) (TV, VCR,
CBL, ASAT, DSAT, DVD, AUX1, CD, AMP, AUX2).
The description of the source button will be shown on
the display along with the current code.
To Next Page
Loading...
