32
Programming Punch Through (VOL / MUTE) onto
another type of device
You can set up the universal remote control so that the
Punch Through function operates another device rather
than the TV. The device must obviously have a volume
control function.
Hold down the setup (17) button for about 3
seconds until is shown.
Press the setup button (17) once more to bring
up .
Press OK (12) . The display will show .
Press OK (12) again. The menu will
appear. This menu allows you to program all
VOL/MUTE commands of one type of device which
you will select in the next step.
Press OK (12) again. The question will
appear on the display.
Select the device that you wish the VOL/MUTE
operation to be changed by using one of the source
buttons (2).
The message and the confirmation
will be shown shortly after each other.
If a device was selected in error that does not have its
To Next Page
Loading...
