53
Deleting commands
Deleting commands from only one source button
Hold down the setup button (17) for about 3
seconds until is shown.
Press the setup button (17) three more times to
bring up the menu.
Press OK (12) to bring up .
Select the menu using the navigation
buttons (13) and press OK (12) .
Select the source button (2) from which you wish to
delete a command.
Confirm the subsequent request with OK
(12) .
The message and the confirmation
will appear shortly after each other.
The remote control will then revert back to normal use.
Deleting commands from all source buttons
Hold down the setup button (17) for about 3
seconds until is shown.
To Next Page
Loading...
