25
Press OK (12) . The display will show .
Press the desired source button (2) (TV, VCR, CBL,
ASAT, DSAT, DVD, AUX1, CD, AMP, AUX2). The
display will show .
Select the device type that is to be programmed to this
source button using the navigation buttons (13) .
(When selecting the button there is no option to
select the type of device because the source button
can only be programmed with TV codes.)
Press OK (12) . The display will show .
Carry out a functional test by pressing the CH+ (11) or
the PLAY (9) button (only for video recorders) several
times (up to 350 times) until the device changes the
channel or otherwise responds accordingly.
The code search begins with the current saved code.
During the search the display will show
(along with the chosen type of device). If you miss the
code, you can go backwards step by step using the
CH- (11) button.
When the device reacts to buttons being pressed,
press OK (12) to save the code. The confirmation
message will be shown. The remote control
will revert back to normal use.
To Next Page
Loading...
