47
The display will show . (Y=2) Enter the
second command.
In our example: Press the record button (9) .
will appear after the second command
(Y=3).
In our example: Press the record button (9) again.
After the third command the confirmation message
will appear and the bell symbol will be
shown on the display.
In order to use this timer, the time must be set in the
remote control.
You can cancel the programming at any time by pressing
the EXIT button(16) .
Deleting command timers
When a command timer is already set up (bell symbol
shown on the display) will appear on the
display instead of (X=1,2,3,4) in the above
steps.
To Next Page
Loading...
