Need help?Do you have a question about the SIMARINE VIA and is the answer not in the manual?
General| Brand | SIMARINE |
|---|---|
| Model | VIA |
| Category | Control Panel |
| Language | English |
Provides an overview of the VIA device, its capabilities, and its purpose in monitoring caravan power systems.
Details the physical dimensions, mounting cutouts, and schematic diagrams for the Simarine VIA unit.
Lists compatible SIMARINE modules such as shunts, inclinometers, and analog input modules that work with the VIA system.
Outlines critical safety precautions for handling batteries, including protection against acid and electrical hazards.
Declares conformity with EU directives (EMC, RoHS) and harmonized standards for the VIA product.
Provides a guide on how to install the VIA, including mounting steps and connecting cables.
Explains the functionality of each button on the VIA device for navigation and control.
Details how to access and navigate through the device's settings menu for various configurations.
Describes the expected display screen after the initial installation and connection of the VIA.
Guides users on setting up battery banks, including type, capacity, and voltmeter selection.
Covers advanced battery configuration parameters for fine-tuning battery monitoring and state-of-charge calculations.
Instructs on how to configure tank sensors, including naming, type, and calibration points.
Details the process for adding and configuring temperature sensors, including type, range, and calibration.
Explains how to configure inclinometer sensors for pitch and roll monitoring, including analog options.
Guides on adding and configuring user-defined sensors, specifying voltage inputs and value ranges.
Covers the configuration of current sensors (shunts) for monitoring electrical current and its impact on battery state of charge.
Customizes screen brightness, language preferences, and measurement units for the VIA device.
Enables setting up alarms for measurements, configuring alarm states, values, delays, and outputs.
Covers viewing, adding, and deleting various device types like batteries, tanks, sensors, voltmeters, and ohmmeters.
Guides on connecting the VIA to a Wi-Fi network in AP or STA mode for remote access.
Allows manual setting of date, time, and time zone, and choosing desired time/date formats.
Provides access to service functions like locking settings, system reset, and viewing system info like firmware version.
Configures specific buttons to display selected monitoring screens like inclinometer, tank, or battery data.
Sets up buttons to control relays, allowing toggling of outputs like water pumps or other connected devices.
Explains how to use the Simarine mobile app for remote control, monitoring, and firmware upgrades.
Details the process for saving current settings to a phone and restoring them, with considerations for hardware changes.
Guides on how to perform a firmware upgrade for the VIA device to ensure optimal performance and features.
Lists key operating parameters including voltage range, temperature range, and power consumption details.
Details display capabilities, connectivity options, dimensions, and maximum supported sensors.
To Next Page