What to do if Simer 2945 Water Pump cable leads are not correctly connected?
If the cable leads of your Simer Water Pump are not correctly connected to the control box, reconnect the leads to match the wiring diagram, ensuring they match the motor lead color code.
What to do if Simer Water Pump has bleeder orifice valve stuck?
If the bleeder orifice check valve in your Simer Water Pump is stuck (standard tank only), free the valve. If it's installed backwards, reverse it.
What to do if Simer 2945 Water Pump check valve is stuck?
If the check valve at the pump discharge of your Simer Water Pump is stuck, free the check valve.
What to do if Simer Water Pump has low voltage?
If your Simer Water Pump is experiencing low voltage, you can try installing a larger wire from the meter to the control box and from the control box to the pump. If the issue persists, it may be necessary to have the power company raise the supply voltage.
How to fix Simer 2945 with broken wire in control box?
To fix a broken wire in the control box of your Simer Water Pump, disconnect the power and then repair or replace the faulty wire.
What to do if Simer 2945 Water Pump has pressure switch problems?
If you are experiencing issues with the pressure switch of your Simer Water Pump, you can try to re-adjust or replace the pressure switch.
What to do if Simer 2945 Water Pump has no voltage at pressure switch?
If there's no voltage at the pressure switch for your Simer Water Pump, replace the faulty pressure switch.
What to do if Simer Water Pump's pressure switch is too far from tank?
If the pressure switch of your Simer Water Pump is too far from the tank, move the switch to within one foot of the tank.
What to do if Simer Water Pump has plugged intake screen?
If your Simer Water Pump has a plugged intake screen, clean or replace it as necessary.
What to do if Simer 2945 Water Pump has tank waterlogged?
If your Simer Water Pump's tank is waterlogged: * For pre-charge tanks, adjust the air pressure to 2 PSI (13.8 kPa) less than the pump cut-in pressure when there is no water pressure on the system. Replace the bladder if necessary. * For air over water tanks, repair or replace the tanks and replace the snifter valves if needed.
General| Cable length | 10 m |
|---|---|
| Voltage | 230 V |
| Maximum delivery height | 6 m |
| Maximum particle size | 3 mm |
| Maximum delivery rate | 300 l/min |
| Motor power | 290 W |
| Max Flow Rate | 300 l/min |
| Max Head | 6 m |
To Next Page
