4 Mounting instructions
To mount the Annunciator, complete the following steps:
1. Unlock the Annunciator using the B-key provided and press location A to open the backplate as shown in Figure 4.
2. Remove the back plate from housing. To remove the back plate, position the back plate at 90º to the housing as shown in Figure 4 and
then tilt and detach the bottom interface of plate from housing first as shown in Figure 5.
Figure 4: Opening the back plate
See Table in step 3 for callout description.
Figure 5: Detaching the back plate
page 8 579-1434 Rev B
Foundation Series 2606-9101 LCD Annunciator Installation Guide
To Next Page
Loading...
