Simplex 4006-9101 - Programming the Leds Mode and Reference Point

Chapter 5. Programming Annunciator LEDs
5-4
Note: Do not program Point 2 (Common Trouble LED
or Point 18 (Comm Loss) on the LED/Switch Annuncia-
tor.
Programming the LED’s Mode and Reference Point
An LED’s mode allows you to specify which point is being
monitored by the LED (called the reference point) and what
point state triggers the LED to turn on. For example, you can
associate an LED with a smoke detector point and have the
LED turn on only when the point enters a trouble state.
1. Follow the steps in “Accessing Annunciator Menus”
earlier in this chapter. Choose LED as the type of
device to program.
<ENTER>=Accept
Prg:[LED]
2. Press <ENTER>. A scrollable list of points appears.
Use the <NEXT> and <PREV> keys to scroll to the
LED point you want to edit. The display appears similar
to the following.
LED Card 5, Pt 1
LED 1/24
3. Press <ENTER>. The next prompt appears similar to
the following:
Table 5-1 Default LED Assignments,
Local Zone LED Module
LED/Color Default Function
Default Reference
Point
1 TROUBLE IDC10
2 TROUBLE NAC2
3 FIRE IDC9
4 TROUBLE IDC2
5 FIRE IDC3
6 TROUBLE IDC3
7 FIRE IDC4
8 TROUBLE IDC4
9 FIRE IDC5
10 TROUBLE IDC5
11 FIRE IDC6
12 TROUBLE IDC6
13 FIRE IDC7
14 TROUBLE IDC7
15 FIRE IDC8
16 TROUBLE IDC8
17 FIRE IDC1
18 TROUBLE IDC9
19 FIRE IDC10
20 TROUBLE IDC1
21 TROUBLE NAC 1
22 FIRE IDC2
23 TRBL NAC 3
24 TRBL NAC4
Table 5-2 Default LED Assignments, Remote LED/
Switch Module
Point Type
Default
Function
Default
Reference
Point
1 Tone-Alert
PIEZO (tracks state
of main piezo).
none
2 Yellow LED
General Trouble (illu-
minates on any trou-
ble).
none
4 Red LED FIRE IDC4
5 Red LED FIRE IDC5
6 Red LED FIRE IDC6
7 Red LED FIRE IDC7
8 Red LED FIRE IDC8
9 Red LED FIRE IDC9
10 Red LED FIRE IDC10
11 Yellow LED TROUBLE. IDC1
12 Yellow LED TROUBLE IDC2
13 Yellow LED TROUBLE IDC3
14 Yellow LED TROUBLE IDC4
15 Yellow LED - TROUBLE IDC5
16 Yellow LED - TROUBLE IDC6
17 Red LED - FIRE IDC1
18 Yellow LED - none none
20 Red LED - FIRE IDC2
22 Red LED - FIRE IDC3
Table 5-2 Default LED Assignments, Remote LED/
Switch Module
Point Type
Default
Function
Default
Reference
Point
Technical Manuals Online! - http://www.tech-man.com