10-4
4007ES Panel Programmer Manual (579-1167)
IP File Transfer
IP File Transfer IP file transfer operates over the Ethernet service port, with files directly copied to the file
system and activated. New Slave Exec data is then downloaded by the master once it is
running.
File Transfer
Connection to the
PC
The Ethernet service port is located on the CPU board behind the inner door assembly
(see Figure 10-3) and connects to the Service PC using a standard straight (non-crossover)
Ethernet Patch Cable. Service Mode Jumper P7 must be connected for this operation which
causes a Service Trouble condition. After, move the jumper to only one pin to disconnect and
retain the jumper for future use.
Figure 10-3. Front Panel Ethernet Service Port
Starting the IP
File Transfer
Utility
This feature enables a download of the Fire Alarm Control Panel (FACP) software features
(Panel Exec, Slave Exec, etc.). This provides a means for recovering previous configurations
(via the File Transfer “History/Undo” tab). This also makes it possible for the FACP to
continue operating during file download operation. FACP down-time is minimal.
The ES Panel IP File Transfer utility can be started from within the ES Panel Programmer or
from the Windows Start menu. To start the File Transfer:
• From within the Programmer. While the programmer is running, click on the
Transfer icon, located along the menu bar at the top of the programmer window. When
the options appear, click on Local Panel.
Figure 10-4. Transfer Icon
• From the Start Menu. Click the Start button. Move the pointer to the Programs
option. When the list of choices appears, move the pointer to the Simplex option and
click on the option containing the programmer. A list of options appears. Click on IP
File Transfer.
When start-up procedure has been completed, the File Transfer Utility appears.
Ethernet Service Port
Service Mode
Jumper P7
To Next Page
Loading...
