9-9
4007ES Panel Programmer Manual (579-1167)
Custom Control, Continued
Selecting Floor
Tab
1. Start the Floor Above/Below Wizard by clicking on the Floor Above/Floor Below Wizard
tab, which is located along the bottom left part of the Custom Control window.
2. Right click in the blank area above the tab. When the list of options appears, select Create
Floor Group. (The ES Panel refers to each set of floor above/below equations as a Floor
Group. This is the name of the group or area that the floor above/below program has control
over.) Enter a name for the Floor Group in the dialog that appears.
.
Figure 9-13. Create Floor Group
.
Figure 9-14. Select Group
To Next Page
Loading...
