7-16
4007ES Panel Programmer Manual (579-1167)
Point Editing for TrueAlert Device, Continued
DCAI Options Use this device type to edit DCAI cards.
Note: A warning appears if the number of DCAI cards added to the Point Editing table does not correspond
to the number of cards added to the job.
The 4100-6103 Dual Class A Isolator (DCAI) card converts the Class B output of an IDNAC
into two isolated Class A outputs. Consult the DCAI manual 579-1029 for more information.
The following editing options are available for this device:
TrueAlert STRB
Appliances Point
Editing
Use this device type to edit TrueAlert Strobe (STRB) appliances. The following editing options
are available for this appliance:
Table 7-12. DCAI Editing Options
Option Description
Custom Label This field can be used to describe the appliance's function, location, or other
descriptive information.
Loop 1 Address The Loop 1 Address is automatically set by the programmer.
Loop 2 Address This virtual address does not need to be adjacent to the loop 1 hardware address.
Table 7-13. TrueAlert STRB Point Editing Options
Option Description
Custom Label This field can be used to describe the appliance's function, location, or other
descriptive information.
Style Select the Style that corresponds to the appliance or device you are programming.
• Indoor.
Available candela
options:
System Default. Sets the candela value to the one selected in
the System Option tab.
15 candela
30 candela
75 candela
110 candela
Hardware. Selecting this option sets the appliance to the setting
indicated on the appliance's configuration switch or jumper.
Operation Select the type of operation the appliance will signal.
General Evac. The strobe is automatically associated with the “ALL VISUAL”
VNAC by default.
Candela Select the candela output of the appliance.
Note: The "Copy/Paste/Special Paste" feature can be used to configure multiple devices identically.
To Next Page
Loading...
