Simplex 4007ES - Chapter 5: 4007 ES Power Supplies; Power Supplies Specifications and Wiring Guidelines

5-1
Chapter 5
4007ES Power Supplies
Introduction This chapter describes the common sections of both the 4007ES Hybrid NAC power supply
and the 4007ES IDNAC power supply.
Wiring Guidelines Class A wiring allows devices to communicate with the FACP even in the event of a single
open circuit somewhere on the loop. Class A wiring requires that two wires are routed from
the power supply to each device, and then back again to the power supply.
Class B wiring allows “T” tapping, and therefore requires less cable distance per installation
than Class A.
Auxiliary power only: Supervision must be provided if the auxiliary power circuit is to be
wired as a power-limited circuit. In order to connect a circuit using PL wiring, the devices
being powered must all be addressable, or a UL Listed EOL relay must be used to supervise
the circuit.
In this chapter
Power Supplies Specifications..........................5-1 Wiring Guidelines ....................... 5-1
IDNet Section Overview...................................5-2 Specifications.............................. 5-2
Device Addressing (Class A and Class B)........5-2 Wiring ......................................... 5-3
AUX PWR/SNAC Overview............................ 5-5 RUI Overview ............................. 5-7
Troubleshooting ................................................5-8
Power Supplies
Specifications
Operating Conditions:
Operating Temperature Range
32
o
F - 120
o
F (0
o
C-49
o
C).
Operating Humidity Range
Up to 93% relative humidity at 90
o
F (32
o
C), non-con-
densing.