Simplex Saturn Series - Heater Installation

14 — Installaon
Saturn load banks are
equipped with space heaters
for cold weather operation
and to prevent condensation,
which can damage the
unit. e heaters require
a dedicated power source
independent of control
power at all times to prevent
startup failure due to cold
environments.
To run power to the
heaters:
1. Run a 120V, 15A, 1-phase power cable into the control panel.
2. Connect the Line leg of the power cable to SH-1
3. Connect the Neutral leg of the power cable to SH-2
4. Connect the Ground leg of the power cable to SH-3
e heaters are set at 50 degrees Fahrenheit. If a dierent
temperature is required, adjust the red thermostat on the front
of the heater.
Heater
inStallation
Figure 16 TB-SH