Installaon — 15
e Polaris provides a
set of Remote Signal Dry
Contacts, which allow you to
integrate the load bank into
your Building Management
System (BMS) or Building
Automation System (BAS)
e dry contacts provide an
alarm message, letting you
know if the load bank has
failed.
To enable BMS/BAS
functionality, wire three
cables to TBR 5-7. Continuity between TBR 5 and TBR 6 indicate
normal load bank operation, and continuity between TBR 5 and
TBR 7 indicate load bank failure.
bmS/baS
inStallation
Figure 17 TBR
To Next Page
Loading...