Warnings and Cauons — 3
equipment only while standing on such insulative mats.
• e National Electrical Code (NEC), Article 250 requires
the frame to be connected to an approved earth ground
and/or grounding rods. is grounding will help prevent
dangerous electrical shock that might be caused by a ground
fault condition or by static electricity. Never disconnect the
ground wire while the load bank is in use.
• Wire gauge sizes of electrical wiring, cables, and cord sets
must be adequate to handle the maximum electrical current
(ampacity) to which they will be subjected.
• Before installing or servicing this (and related) equipment,
ensure that all power voltage supplies are completely turned
o at their source. Failure to do so can result in hazardous
and possibly fatal electrical shock.
• In case of accident caused by electric shock, immediately
shut down the source of electrical power. If this is not
possible, attempt to free the victim from the live conductor.
AVOID DIRECT CONTACT WITH THE VICTIM. Use
a nonconducting implement, such as a dry rope or board,
to free the victim from the live conductor. If the victim is
unconscious, apply rst aid and seek immediate medical
attention.
• Never wear jewelry when working on this equipment. Jewelry
can conduct electricity resulting in electric shock or may get
caught in moving components causing injury.
• Keep a re extinguisher near the hardware at all times.
Do NOT use any carbon tetra-chloride type extinguisher.
Its fumes are toxic, and the liquid can deteriorate wiring
insulation. Keep the extinguisher properly charged and be
familiar with its use. If there are any questions pertaining to
re extinguishers, please consult the local re department.
• e illustrations in this manual are examples only and may
dier from your load bank.
• Load Bank warranty is void if incorrectly cooled.
To Next Page
Loading...