2-7
IDNet Host. Selected when the TrueAlert Addressable Controller is used with a 4010 FACP.
IMPORTANT:
• The Addressable Controller cannot be connected to hardwired NAC
channels (TB7) and an IDNet host (TB2) at the same time. Make sure only
one interface is selected (IDNet, RUI, or Hardwired).
• The Addressable Controller LEDs do not indicate a trouble if the IDNet
channel is disconnected. The only trouble indication is at the host panel.
Dual NAC Host. Selected when the Addressable Controller is hardwired to the host FACP using
TB7 on Figure 1-2. The Addressable Controller can be hardwired to any compatible FACP.
IMPORTANT:
• The Addressable Controller cannot be connected to a RUI host (TB1) or an
IDNet host (TB2) while it is connected to hardwired NAC channels (TB7) at
the same time. Make sure only one interface is selected.
• The Addressable Controller LEDs do not indicate a trouble if the hardwired
channels are disconnected. The only trouble indication is at the host panel.
IDNet Repeater Card Options. Refer to Table 2-3, below, for a description of what happens
when Switch 5 is set.
Note: In Table 2-3, “Yes” denotes the IDNet Repeater Card has been correctly wired
and mounted to the Addressable Controller.
Table 2-3. (SW4) Switch 5
(SW4) Switch 5
Setting
IDNet Repeater Card
Connected to
Addressable Controller?
System Status
Yes Normal
ON
No
Yes
Configuration Mismatch Trouble
OFF
No Normal
Appliance Blink on Poll Disabled. Stops notification appliance LEDs from blinking when the
appliances are polled during normal operation.
Appliance Blink on Poll Enabled. Forces notification appliance LEDs to blink whenever they
are polled (i.e., every few seconds). Note that a blinking LED at the appliance indicates that
polling was successful, and does not indicate whether the system detected a problem with the
appliance (the host panel must be used to determine appliance status).
Horn Volume: Low. Sets the horn volume at Low for all A/Vs and Horns connected to the
Addressable Controller. Horn volume is not configurable on an appliance-by-appliance basis.
Horn Volume: High. Sets the horn volume at High for all A/Vs and Horns connected to the
Addressable Controller. Horn volume is not configurable on an appliance-by-appliance basis.
Continued on next page
System Configuration, Continued
Hardware
Configuration DIP
Switch (SW4),
continued
To Next Page
Loading...
