3-6
To delete a 4009 TrueAlert Addressable Controller from the list of device types from the
Programming menu:
1. From the Programming: [Configure Points] menu item, press ENTER.
2. Press NEXT until the Configure Point: [ZAMS/RIAMS/IAMS] menu item
comes up. Press ENTER.
3. Press PREVIOUS until you reach the IDNet: [Delete IDNet Point] menu
item. Press ENTER.
4. The display now reads IDNet Device: M1-x where x is the first available IDNet
address. If needed, use the PREVIOUS or NEXT buttons to scroll through the addresses.
Press ENTER on the address you want to delete.
5. Press ENTER again to verify your selection. The display reads
** Operation Complete ** when you are done.
Deleting the 4009 TrueAlert Addressable Controller
Overview
To Next Page
Loading...
