1-1
The 4009-9401 TrueAlert
™
Addressable Controller is a self-contained adjunct panel for use with
TrueAlert addressable notification appliances. The base version of the Addressable Controller is a
single-board system consisting of three Signaling Line Circuit (SLC) channels, a power supply
and charger, slave interfaces for IDNet
™
and RUI protocols, and two conventional Notification
Appliance Circuit (NAC) inputs for hardwired control. Option cards are available to provide the
following additional capabilities:
• 4009-9812 Class A Adapter Option Card. Allows fault tolerance in the case of
open circuit wiring faults on the three TrueAlert SLCs.
• 4009-9809 IDNet Repeater Option Card. 4010 only. Regenerates and provides a
power and distance boost for the IDNet channel. The 4009-9809 takes the IDNet signal
from the 4009 receiver and retransmits it on its output side at host panel IDNet levels.
When the IDNet Repeater Option Card is used, the Fiber Optic Receiver Option Card is
not available for the 4009 TrueAlert Addressable Controller.
• 4009-9810 (Class B)/4009-9811 (Class A) Fiber Optic Receiver Option Card.
4010 only. Receives IDNet communication over a fiber optic link and regenerates the
IDNet signal. The Fiber Optic Receiver Option Card is used with the 4090-9105
(Class B)/4090-9107 (Class A) Fiber Optic Card to form an IDNet fiber optic link.
The table below lists the topics in this chapter.
Topic See Page
Introduction to TrueAlert 1-2
The 4009 TrueAlert Addressable Controller 1-3
Control Types 1-5
Hardware Components 1-6
Chapter 1
Introduction to the TrueAlert
Addressable Controller
Introduction
In this Chapter
To Next Page
Loading...
