Simplex TrueAlert 4009-9401 - Page 48

Simplex TrueAlert 4009-9401

48 pages

To Previous Page

To Previous Page

Loading...

574-762

Rev. E

© 2005, 2007 Tyco Safety Products Westminster, Westminster, MA 01441-001 USA. Specifications and other information shown were current as of publication and are subject to change without notice.

firealarmresources.com

Table of Contents

default chapter5
- Table of Contents5
Chapter 1 Introduction to the Truealert Addressable Controller9
- Introduction9
- In this Chapter9
- Introduction to Truealert10
- Overview11
- The 4009 Truealert Addressable Controller11
- Figure 1-1. Simplex 4009 Truealert Addressable Controller11
- Control Types13
- Overview14
- Hardware Components14
- Truealert SLC Channels14
- Battery Charger14
- Idnet and RUI Ports14
- DIP Switches14
- Figure 1-2. 4009 Truealert Addressable Controller System Board15
- Figure 1-3. System Trouble Indicators16
- System Trouble Messages17
- Isolating Earth Grounds18
- AC Power Indicator (LED 9)18
- System Overview: Applications Diagram20
- Illustration20
- Figure 2-1. 4009 Truealert Applications Diagram20
- System Overview: Selective Signaling21
- Illustration21
- Figure 2-2. Selective Signaling Example21
- System Configuration22
- Overview22
- SLC Appliance DIP Switches (SW1, SW2, SW3)22
- Figure 2-3. SLC Appliance Settings (SW1, SW2, SW3)22
- Hardware Configuration DIP Switch (SW4)23
- Address/Software Configuration DIP Switch (SW5)26
- Figure 2-4. Idnet Address Settings (SW5)26
- Figure 2-5. RUI Address Settings (SW5)27
- System Installation29
- General Information29
- Tools and Equipment Required29
- Required Documentation30
- General Notes30
- Mounting the 4009 Truealert Addressable Controller31
- Figure 2-6. Installing the 4009 Back Box31
- Wiring the 4009 Truealert Addressable Controller32
- System Power Requirements33
- Figure 2-7. 4009 Truealert Addressable Controller Connection Diagram33
- Mounting and Wiring Peripheral Appliances34
- Installing Option Interfaces35
- Overview35
Chapter 3 4010 Panel Programming37
- Overview37
- In this Chapter37
- Overview38
- Step 1: Starting the Programmer38
- Step 3: Configuring 4009 SLC Point Types40
- Step 4: Editing Point Labels40
- Step 5: Saving a Configuration41
- Step 6: Specifying Signal Operation41
- Deleting the 4009 Truealert Addressable Controller42
- Overview42
- 4010 Quick CFIG43
- Overview43
- Quick CFIG Steps43

Other manuals for Simplex TrueAlert 4009-9401

Operation Reference8 pages

Related product manuals

Simplex TrueAlert 4009 Series

Simplex 4001 Series