Landlord / 1700 / 2700 Series
1/2001 17
TP 300-2226-02-LL-SMA
Burnishing the Electric
PTO Clutch
1. Select a safe area to operate the mower deck. With
the drive in neutral, the PTO switch disengaged, and
an operator in the seat, start the tractor engine. Run
the engine at full throttle.
2. Engage the PTO switch and run the deck for fifteen
seconds. Disengage the PTO switch and wait for the
mower drive belt to stop.
3. Repeat step 2 above ten times, and then re-check the
mower blade stopping time. (Stopping time must be
five seconds or less.)
SAFETY INTERLOCK
SYSTEM TESTS
This unit is equipped with safety interlock switches
and other safety devices. These safety systems are
present for your safety: do not attempt to bypass
safety switches, and never tamper with safety
devices. Check their operation regularly.
Operational SAFETY Checks
Your unit is equipped with a seat switch safety sys-
tem. Check the seat switch operation every fall and
spring with the following tests.
Test 1 — Engine should NOT crank if:
• PTO switch is ON, OR
• Brake pedal is NOT fully depressed (parking
brake OFF).
Test 2 — Engine SHOULD crank if:
• PTO switch is OFF, AND
• Brake pedal is fully depressed
(parking brake ON).
Test 3 — Engine should SHUT OFF if:
• Operator rises off seat with PTO engaged, OR
• Operator rises off seat with brake pedal NOT
fully depressed (parking brake OFF).
Test 4 — Blade Brake Check
Mower blades and mower drive belt should come to
a complete stop within five seconds after electric
PTO switch is turned OFF (or operator rises off
seat). If mower drive belt does not stop within five
seconds, readjust the PTO clutch as described in
the ADJUSTMENTS section or see your dealer.
NOTE: Once the engine has stopped, the PTO
switch must be turned off after the operator returns
to the seat in order to start the engine.
WARNING
If the unit does not pass a safety test, do not
operate it. See your authorized dealer. Under
no circumstance should you attempt to
defeat the purpose of the safety interlock
system.
To Next Page
Loading...
Need help?
General
