CE34/44/54 Waypoint / route menu Chapter 7-17
DataCard status
1
Press [1] to find out what data (if any) is stored on the DataCard
The capacity is divided into two databanks: DATABANK 1 and 2
which can hold approx. 2 x 450 Kb data. Toggle between the two
databanks with the +/- keys.
Save on DataCard
3
Press [3] to call up a new INFO window where you can see which
data will be transferred i.e. routes, waypoints, etc. and how much
space it will take up in bytes + percentage of max. storage capacity.
The actual date and time will be saved with the data transfer.
+/-
Use the +/- keys to toggle between DATABANK 1 and 2
A-B
Use the alphanumeric keys to add a name to the data in the selected
databank
Use the cursor key to go to the ‘Act ion’ column to decide which
action you want taken for each mentioned category of data (toggle
with +/- keys) - see section 7.9.1.
If you choose to MERGE the data already stored on the DataCard
with the data coming from the Internal memory, the bottom line in
the window will ask you to press [ENT] to: Calculate databank after
merge.
ENT
Press [ENT] to activate ‘Save selected data on DataCard’
You will now receive a warning about which data on the DataCard,
in the selected databank, will be overwritten. Press [ENT] to accept.
After the data has been transferred, you will receive a status report.
MENU
Press [MENU] to exit function
Load from DataCard
9
Press [9] to call up a new INFO window where you can see which
data is stored in Databank 1 or 2 on the DataCard - see display
example next page.
+/-
Use the +/- keys to toggle between DATABANK 1 and 2
To Next Page
Loading...
Need help?
General
