CE34/44/54 Waypoint / route menu Chapter 7-19
MENU
Press [MENU] to exit and *reboot (only if loading “Setup”)
*) When the system makes a ‘reboot’ the screen will turn black for a
brief moment, then the system will re-start and automatically return
to the active display which was on the screen before you made the
transfer.
7.9.1 List of criteria for data transfer in the Action column
OVERWRITE - will overwrite existing data in the memory you are trans-
ferring data to. Whenever a new ‘Setup’ is transferred into the main unit, the
system will reboot, the screen will turn black for a brief moment and then
restart and automatically return to the active display on the screen before you
made the transfer.
Transfer of ‘Setup’ can only be completed between identical units.
MERGE - will mix the transferred data with the data in the memory you are
transferring to. Press [ENT] to calculate memory after merge. Identical data
will be sorted automatically and not saved twice i.e.:
• ‘Marks/waypoints’ of same position, name and symbol.
• ‘Lines’ which are identical.
• ‘Routes’ of same name, equal number of routepoints (not necessarily in the
same position), but with the exact same start point and end point.
• ‘Targets’ of same position, name and symbol.
• ‘Tracks’ which are identical.
• ‘Setup’ can not be merged.
DELETE - will delete existing type of data from the memory you are trans-
ferring data to.
NO - no action will take place. The data will remain unchanged.
To Next Page
Loading...
Need help?
General
