Simrad HH33E - WP Select Mode; Plotter Mode

Simrad - HH33 Installation and Operation Instructions 21
NAV – return to normal mode•
GO – Reset the cross track error (XTE)•
SQL •
– Go to WP select Mode
SQL •
– Go to Plotter Mode
Other key – error beep•
3-13 WP Select Mode
WP LIST 13
CAMP 1 MOB 1
CAMP 2 MOB 2
CAMP 3 MOB 3
DOCK 1 PARK 1
DOCK 2 PARK 2
ESC ENTER
CH • / – Page up down the list;
SQL •
- Go to Plotter Mode;
SQL •
- Returns to Navigation Mode
Note: During WP Select Mode, press ENTER right-key to ash the rst WP, then press
CH
/ to select next WP, press ENTER right-key again to set the WP as your next
destination and enter navigation mode.
3-14 Plotter Mode
During plotter Mode:
Soft Key It will zoom in/out the circle to see more/less area.•
SQL •
Go to Navigation Mode