Simrad HH33E - Track Log; Erase Track; Reset (Reset to Factory Defaults)

Simrad - HH33 Installation and Operation Instructions46
MENU SELECT
RADIO SETUP
DSC SETUP
>GET BUDDY
GET BUDDY
ON
>OFF
Select GET BUDDY and then press ENTER.1.
Select ON or OFF as required, then press ENTER to conrm the selection.2.
Note: For EU, use clone software to Enable/Disable the GET BUDDY menu.
4-11 Track Log
Set the distance interval to 25m, 50m, or 100m for recording the track points when
navigating.
MENU SELECT
DSC SETUP
GET BUDDY
>TRACK LOG
TRACK LOG
25M
>50M
100M
1. Select TRACK LOG, then press ENTER, the 25m, 50m, 100m appear on the screen.
2. Select your desired and press ENTER to conrm.
4-12 Erase Track
Erase the TRACK HISTORY from the plotter screen.
MENU SELECT
GET BUDDY
TRACK LOG
>ERASE TRACK
ERASE TRACK
YES
>NO
Select ERASE TRACK, then press ENTER, the radio asks for conrmation.1.
Select Yes, then press ENTER to erase the track line of the plotter screen.2.
4-13 Reset (Reset to factory defaults)
Use RESET to return every setting on the radio to the factory defaults, except your MMSI,
Group MMSIs and ATIS MMSI.
Select RESET, press ENTER, the radios asks for conrmation.1.
Select yes, press ENTER to reset the radio and return to the menu.2.