Simrad HH33E - Settings: COG;SOG (Course & Speed Display Options); GPS Alert

Simrad - HH33 Installation and Operation Instructions 35
4-6-6 Settings: COG/SOG (Course & speed display options)
If your position and time data is being updated, you can use COG/SOG to choose whether
to show or hide your course over ground (COG) and speed over ground (SOG) data on the
screen.
Note: Despite the COG/SOG setting, if TIME DISPLAY is ON, the course and speed will not
display on screen.
COG/SOG
>ON
OFF
MENU
BUDDY LIST
CONTRAST
> GPS/DATA
GPS/DATA
MANUAL
>SETTING
SETTING
TIME DISPLAY
LL DISPLY
>COG/SOG
COAST GUARD
356
°
12.6KTS
27
°
34.126’N
109
°
55.568’W
In the radio setup MENU, select GPS/DATA, then SETTING.1.
Move the cursor to COG/SOG and push ENTER.2.
Select ON or OFF as desired, In this example, ON has been selected, so the screen 3.
shows the bearing and speed.
If COG/SOG is set on, the time will not display on screen.
4-6-7 GPS Alert
You can choose NO GPS DATA alarm sound on/o.
GPS ALERT
>ON
OFF
MENU SELECT
BUDDY LIST
CONTRAST
>GPS/DATA
GPS/DATA
MANUAL
>SETTING
SETTING
LL DISPLY
COG/SOG
>GPS ALERT
In the radio setup MENU, select GPS/DATA, then SETTING.1.
Move the cursor to GPS ALERT and press ENTER.2.
Select ON/OFF as desired, in this example, ON has been selected, so if GPS DATA is 3.
not available, the NO GPS alert will sound.