Simrad HH33E - DSC Setup (US only)

Simrad - HH33 Installation and Operation Instructions40
Select RADIO SETUP then NMEA OUT.1.
Select ON/OFF then press ENTER to conrm your desired choice.2.
4-8 DSC Setup (US only)
The submenu is used to set behavior of the function. Items are available for selection.
Hold down CALL/MENU then select DSC SETUP, press ENTER to enter DSC SETUP sub-
menu in which there are 5:
USER MMSI GROUP SETUP
INDIV REPLY DSC SELECT
LL REPLY
4-8-1 Enter or Check Your USER MMSI (USER MMSI)
Note: You must enter your user MMSI before you can access the DSC functions.
When you have entered your MMSI correctly, you can display it any time.
USER MMSI
INPUT AGAIN

>USER MMSI
GROUP SETUP
INDIV REPLY
INPUT USER
MMSI

USER MMSI
876543210
>STORE
CANCEL
USER MMSI
876543210
>STORE
CANCEL
The cursor is at DSC SETUP and press ENTER.1.
The cursor is at USER MMSI. Press ENTER.2.
If you have already entered your MMSI, it is shown on the screen.
If this is the rst time that you are entering your MMSI, a dashed line appears with
the cursor under the rst position. You need to enter your MMSI along the dashed
line, one number at a time.
Press CH3.
/ to select the rst number of your MMSI. Press ENTER to conrm the
number and move to the next position. If you make an error, select the < character
then press ENTER to backup.
When you have entered the last number, push ENTER to advance to the next screen. 4.
The cursor is at STORE.