Page 21
3) After CAREFULLY taking Cycraft out of the crate, install the rear two wheels by
first removing the MSCU cover as shown in the figure below. Note that the front
two wheels are already installed.
Be careful not to step on and damage the floor pressure sensor springs and
switches installed on the frame beneath the cabin
4) Adjust the heights of the wheels by rotating the nut on top of each wheel using
wrench until Cycraft is raised sufficiently for transport. Then, carefully roll Cycraft
to its destination location. After Cycraft is positioned in it’s installation location,
lower Cycraft by turning the wheel height adjustment nuts counterclockwise and
disassemble each of the wheel assembly.
To lift up the base frame,
turn the nut clockwise
3 x Hex head Bolt M12 x 35L
Socket wrench (19mm) &
Extension bar
(Over 200 mm)
To Next Page
Loading...
